Replacement agitate coupler used for some GE, Hotpoint, and RCA washer models.
Directly Replaces: WH49X10042, WH43X10032, WH02X10037, WH43X10009, AH1517844, WH02X1200, WH2X10037, WH2X1200, WH43X0137, WH43X137, 175D2110P002, 175D2846P001, LP10042, 1195917, 1264702, AH1482517, AH1517844, AP3995059, AP3964635, EA1482517, EA1517844, EAP1517844, PD00001044, PS1482517, PS1517844.
- Agitator drive bell connects transmission drive shaft to the agitator base.
- Coupler also known as the drive bell or drive block.
- Fits newer top load washers.
- Includes (1) Agitator Drive Bell, (1) Bolt.
- Color: Pale Yellow.
- Material: Plastic.
- Finish: Matte.
- Dimensions: 3-7/16"L x 3-7/16"W x 3-1/8"H.
The agitator coupler connects the agitator to the drive system.
Failure Symptoms: When the agitator coupler fails, the unit may not agitate properly or at all.
How to Test: Remove the agitator and check the coupler for excessive wear or damage. If the coupler is worn out or damaged, it should be replaced.
Disclaimer: Information and recommendations contained herein are believed to be accurate as of the date hereof. Since the conditions and methods of use of the information referred to are beyond control, ApplianceRepairForum.com and Thrifty Appliance Parts LLC, cannot be held liable for results obtained or arising from use or reliance on such information.
The User assumes responsibility associated with making test measurements, adjustments, parts replacements and any other action necessary to perform any recommended procedures. It is the responsibility of the User to ask for clarification if a recommendation is not fully understood, including the risks and hazards associated with the recommended procedures.
It installs a little loose which affects the life of the part. It does work though.